Trim pattern dossier / TB-RTC-TWC-025
Ten patterns need ten separate decisions.
This copper-base rhinestone family ranges from narrow to broad rows. Choose the photographed pattern, test its bend and plan cuts before converting a decoration line into an order quantity.
Name a pattern before naming a quantity.
Recorded family
10 patterns
Photographs can make different row arrangements appear interchangeable. Select the exact pattern image and mark its stone spacing, apparent finish, row count and measured width. Keep a labeled physical swatch for every approved option.
0.9–1.5 cm
Width changes the receiving design.
A narrow trim can follow a delicate seam where a broad one may cover stitching or overwhelm a small panel. Pin each candidate to the actual garment, shoe or accessory at full scale.
Test the tightest curve.
Bend a mounted sample around the smallest intended radius. Check whether copper links twist, lift or expose an unwanted gap between stones. A flat ruler test cannot reveal this behavior.
Decide where the pattern may end.
Map every visible join so a motif does not stop abruptly at the front of the product.
Allow for cut waste at the end of a repeat, not just the measured design perimeter.
Approve the finishing method for exposed cut ends and the receiving substrate.
Calculate usable length, then confirm the sales unit.
The source describes approximately 90 cm per listed unit, not a guaranteed current pack length. Multiply the approved run by finished-item quantity, add joint and cutting allowance, and ask the supplier to state which length or pack unit the current MOQ of 50 applies to, plus price and packing, in writing.
Compare a shaped border alternative.
The marquise-and-teardrop trim uses a different repeating outline. Browse Rhinestone Trims & Chains to compare application geometry before selecting a family.
Pattern-specific RFQ
Send a swatch, width and run calculation.
Twisted trim FAQ
- 01
Is every pattern the same width?
No. The record spans ten patterns about 0.9–1.5 cm wide. Select an exact pattern and verify its measured sample width.
- 02
Is one order unit always exactly 90 cm?
The source lists approximately 90 cm per unit. Ask the current quote to confirm actual sales unit, usable length and cutting tolerance.
- 03
What are the rhinestones made of?
The record identifies rhinestones on a copper base but does not specify stone composition. Request that specification if it affects the project.